The New Oil Sump & An Engine Start

Overall, I have been messing with the new oil sump. There was some fitting that I had to do, like moving the filler neck, making a dipstick, etc.

Here was the first go-around. You can see the interference problem with the engine mount.
I prevailed on a local welder friend to move the filler neck and to insert a patch. The mounted plate you see is just temporary so I could pressurize it a bit for leak testing.


This thing has a large opening at the bottom so I can gain access to the six mounting studs. The old Continental sump had the mounting screws on the outside, but I had David change them to the inside to make the flange neck wider and more robust. At least that was my theory.

I went with a thinner bottom cover plate than David had provided, in order to gain a little more cowling clearance. I wasn't sure if I would get a good gasket seal, so I doubled the number of mounting screws to 16. Now it looks like something off of a locomotive steam engine. Obviously, I have no idea what I am doing here.

Last Sunday I cobbled enough of it together to actually start the engine. After a little coaxing I managed an actual start and it ran pretty well. This was pretty significant in that it verified the new EFI sensor mounting assembly. I will still have to fine tune the timing adjustment but I am definitely in the ballpark.

I let the whole thing set for a couple of days but when I came back I was dismayed to find about 1/2 cup of oil on the floor. Almost every screw had oil slowly dripping off of it. I drained the oil and tried to figure what to do next. It looked like the sealing gasket was dry and that the oil was migrating through each screw, so I took the approach of sealing the hole. After several trips to town, I found some bonded sealing washers (McMaster P.N. 94709A214) and installed them, and gave the screw threads a swipe with Tite-Seal.

This photo shows how fun it will be to change the oil. Just click on it to make it uglier.


I refilled the oil tank and will go out later today to see how it turns out.


This custom oil sump business has been a royal pain in the arse and given the chance to do it over, I would not have gone this route. Remember, the reason I went with a modified sump was solely to cut down on a bit of drag. The costs do not seen to outweigh the potential gain.

If I can't get this working right, there is always the Sawsall.

Wish me luck.